Laguna Tools SMARTSHOP I 4x8, Руководство пользователя

Страница: 25 / 50

Cutter
Contact button
25
Automatic Z Origin Point [tool touch off]
The machine is provided with an automatic tool
height adjustment. Place the contact button on
the clean spoil board directly under the cutter.
To activate the automatic tool height adjustment
press Menu & On/Off key at the same time on
the control pad. This will cause the cutter to
move slowly down. Once the cutter touches the
contact button, electrical contact is made and the
cutter will move up and away from the contact
button. The machine now knows the height of the
cutter.
There is also a manual method that is detailed
below:
1.
Fit a flat bottom router bit to the spindle.
2. Jog [Z] the tip of the tool down so that it is just
above the top of the spoil board using the
“Continues” (CONTINUOUS???) button.
3. Step down in slow mode [0.1mm 0.004” each time the button is pressed] while
turning the router collet by hand in the reverse direction.
As you feel pressure, stop jogging down.
Note: Do not turn the router bit (BY HAND???)as it is sharp and could cause injury.
4.
Select the distance mode and enter 0.0254mm [0.0001”] Press Z+ [UP] and
rotate the cutter in the reverse direction until the cutter is free to move and there
is no drag. The cutter is now within 0.001” above the spoil board.
5. Once the router bit is at Zero press the Z-0 / 8 button to set the zero point.
6. Jog the router bit up or press the origin button to move the router bit up and to
the origin point.