Laguna Tools PX-20 SHEARTEC II, Руководство пользователя

Страница: 37 / 76

37
Calibrating the Thickness Scale (Cont’d.) -
1.) Use the Table Height Adjustment handle
(Fig. A) to raise the table until the infeed roller is
“approximately 1/16” above the calibrating board.
2.) Remove the calibrating board from the planer.
3.) Connect power to the planer and turn
“ ON .”
4.) Turn the height adjustment handle clockwise, one complete revolution, to lower the carriage
and run the calibrating board (previously machined face “ D own”) through the planer. Lock
(“ D own” position) the Carriage Lock.
5.) Repeat Step 5 until the planer removes the entire top surface of the calibrating board.
NOTICE! Drawing pencil marks across the width of the top of the calibrating board in several
locations can make it easier to determine when the entire surface has been planned.
6.) Measure the thickness of the calibrating board with a caliper.
7.) Loosen the two screws of the Thickness Scale pointer and adjust the pointer
(Fig. B) until it
corresponds to the measured thickness and then tighten the screws.
THICKNESS SCALE
CALIBRATION