Laguna Tools MSANWB37X75-10-0197, Руководство по эксплуатации

Страница: 11 / 42

INSTALL SANDING BELT INSTALL SANDING BELT
1. Disconnect machine from power source 6. Insert new belt by starting first on the upper roller ( F ), then the lower
2. Shut "OFF" the air tension switch ( C ). roller. Center the belt while avoiding contact with limit switch fingers that
3. Remove the pad lock lever ( D ) by turning it counterclockwise. are located on each side of the belt.
4. Remove the pad block ( E )
5. Remove the old belt by sliding it out the end
( See Figure 4 )
Make sure the direction of the arrows on the inside of the belt matches the
rotation of the machine. Check that the edges of the sanding belt are not
chipped or torn.
7. Replace pad block ( E ) and tighten pad lock lever ( D ).
8. Turn "ON" the air tension switch ( C )
9. Make sure there is clearance between the belt edges andlimit switch fingers
on either side. If there is not, make the appropriate belt corrections
according to the procedure above ( with the air tension turned off )
as necessary.
Machine will not start if a limit switch is depressed.
Figure 4 - PLATEN TYPE
6
NOTICE !!
NOTICE !!