Part# VDL-18
26
REV#082020
13.
Make sure that you use the proper size and type of blade.
14.
Hold the work piece firmly against the table. Do not attempt to saw stock that
does not have a flat surface facing down, unless a suitable support is used.
15.
Use a push stick at the end of a cut. This is the most dangerous time because
the cut is complete, and the blade is exposed. Push sticks are commercially
available.
16.
Hold the wood firmly and feed it into the blade at a moderate speed.
17.
Turn off the machine if you must back the material out of an uncompleted or
jammed cut.
Disconnect the power from
the bandsaw.
1.
Remove the throat plate
by removing the clamp
screw.
A lot of people do not like to change the blades and go to great lengths to avoid doing it. To
use the bandsaw to its greatest advantage, you will have to use the appropriate blade and
track it quickly. This is a habit that can be easily developed. If you use a step-by-step method
of tracking and tensioning, the procedure should only take a minute or two. Be careful when
using blades, especially wide ones. Always use gloves and safety glasses.
Clamp screw
Throat plate
Table split clamp screw
Table split clamp slot
Blade in table split
Plastic blanking block
Содержание Dake VDL-18
