Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
985017/985018
10
REV122021
7. Check to see that the blade is positioned correctly and tighten screw. Consult blade
manufacturer for proper PSI tension.
8. Install blade cleaning brushes and guards that were removed earlier.
BLADE TRACKING ADJUSTMENT
-
Saw blade should track on each wheel with the back of the blade up to, but not riding on
the wheel flange. Adjust as follows:
Idle Wheel
1. Open top cover on left end of machine to gain
access to idle wheel. Idle wheel is mounted on
a slide block, which contains the blade height
adjustment screws.
2. To raise the blade, loosen the two screws
toward center of machine (A, on right) one-half
turn and tighten the other two screws (B) one-
half turn. Be sure tension screw (C) is properly
tightened to not over adjust.
3. Check by running machine after each
adjustment.
To lower blade, reverse procedure – loosen screws
(B) and tighten screws (A).
Drive Wheel
1. To raise the blade, loosen two cap screws (A, on
right) and tighten screws (B and C). All four screws
must be turned equally and in small increments
(about ½ turn) to avoid over adjustment.
2. Check by running machine after each adjustment.
To lower blade, reverse above procedure – loosen
screws (B and C) and tighten screw (A).
