SAFETY & OPERATIONAL PRECAUTIONS
For proper performance do NOT modify, substitute nozzle, hose diameter or length.
Manufacturer assumes no liability for the use or misuse of this unit.
Wear protective clothing, gloves and eye-wear when working with chemicals.
Always direct the discharge away from people and electrical devices.
For pressures over 100 PSI, remove the discharge valve or lower pressure
Follow the chemical manufacturer’s safe handling instructions.
Turn off solution supply and air when unit is not in use for extended periods.
TO INSTALL (REFER TO DIAGRAM ON NEXT PAGE)
1. Remove the tube lock check valves from the enclosed bag and install as shown in the drawing.
2. Mount each of the triple foam sticks to either side of the bay. The longest bar should be mounted so that its foam is the first to contact the vehicle. They should be mounted so
that the last hole (in the cap) hits the bottom of the vehicle. The stick sets should be "mirror-images" of each other once mounted.
3. Run 1/2" I.D. chemical tubing from each of the three "solution pumps" to the middle of the arch and connect with a tubing tee (not included).
4. From there step down to 3/8" I.D. tubing and connect to the solution check valves. The tubes should be the same length for the best performance.
5. Run 1/4" air tubing from your compressed air supply to the middle of the arch and push connect it to the 1/4" tube lock of the tee. (not included)
TO OPERATE
1. As a starting point turn the air needle valve on each stick set completely clockwise, then open it 1/2 turn counterclockwise.
2. Activate the solution and air pressure. Wait a few seconds to purge the air out of the solution tube and for the solution to get to the foamers. Solution pressure must be between
40 - 60 PSI. Air pressure/volume is controlled by the needle valves.
3. If the foam isn't acceptable, turn the needle valve
slightly
counterclockwise for dryer foam and
slightly
clockwise for wetter foam. If the needle valve is open too much, the foam
will be pushed past the first holes and air only will blow out the fist hole or two. If this happens, turn the needle valve slightly clockwise until all the holes are foaming. Once the
sticks are foaming properly, no further adjustment should be needed. You are ready for operation.
910310 • Triple Foam Stick Set
- Page 2 -
Содержание 910310
Страница 3: ...910310 Triple Foam Stick Set Page 3 ...
