Transitional Shades
Installation Instructions
ADJUSTING THE LOWER STOP
Inside/Outside Mount - Right Control
1. Measure how much shade needs to be raised or lowered. (IB)
2. Remove shade from window opening. (IB)
3. Remove cassette cover opposite of clutch (idle end of the shade)
4. Lower shade to original lower limit.
5. Pull slightly on chain to create slack in clutch.
6. Insert large flat blade screwdriver into end of shade.
7. Turn clockwise to raise shade or counter clockwise to lower shade.
8. Pull on chain to make sure desired length is correct. If not, repeat
steps 5 - 7.
9. Reattach cassette cover (and return shade to window opening if
(IB).
Inside/Outside Mount - Left Control
Follow steps 1 - 6 above.
7. Turn counter clockwise to raise shade or clockwise to lower shade.
8. Reattach cassette cover (and return shade to window opening if
(IB).
Step 3
REMOVE THE SHADE (if necessary)
Small Cassette
To remove shade from spring loaded bracket, raise the shade and
push in on the top front of the headrail.
Tilt the bottom of the shade toward the room to remove from the
brackets.
Large, Sure-Lift or Sundown Cassette
Push the top of the cassette towards the window, then insert a flat
blade screwdriver into the release tab and twist.
Tilt the shade toward the room to remove from the brackets.
INSTALL CORD TENSION LOCK
See Cord Tension Lock installation Instructions
INSTALL HOLD-DOWNS (Optional)
See Hold-Down Installation instructions
INSTALL HANDLE
/HANDLES
(Accu-Rise Only)
At center of bottom rail, place a small pencil mark. Push handle
onto rail until securely in place, then adjust right or left to center.
If your shade is wider than 48" you will be supplied with 2 handles
to install.
Push handles onto rails from each end and slide until
handles are spaced 18" from center
.
Two handles ensure that wider shades are pulled with even tension
so that the fabric does not get damaged.
Step 4
CARE AND CLEANING
Allure Transitional Shades have an extraordinary and remarkable
self-dusting feature. Simply roll the shade up into the headrail
and back down again to remove
dust. The shading can be
feather dusted or vacuumed at a low setting. Spots can be cleaned
with a damp sponge and mild soap. To avoid discoloration, do not
use chemical cleaners. Ultrasonic cleaning is not
recommended. It will damage the shade.
Note:
In dry conditions, static may occur causing front and back
panels to stick together or fabric to wave.
If this happens, please spray with anti-static guard. This may have to
be done periodically to eliminate static buildup.
Recommended brand is “Static Guard”.
Small Cassette
Push In
Tilt Bottom of Shade
Large, Sure-Lift & Sundown Cassette
18-8004-CASS NOV. 2018
