LAEGENDARY THUNDER, Руководство пользователя

Страница: 27 / 59

27
www.LAEGENDARY.com
Troubleshooting
Car runs in circles
without touching the
steering wheel
The car can go forward
and backward but does
not steer left or right
The receiver light is
flashing slowly; the ESC
light is flashing rapidly
and there is no action
on the transmitter
1.Steering trim is not set
properly.
2. The spring or E-clip on the
Servo Saver is loosened or
missing
1. The servo plug is not
connected to the receiver.
2. The steering angle is set to
the lowest settings.
3. The servo steering is
defective.
The car and remote are not
connected properly
1.Place the car on a stand,
move the steering wheel and
check if the car steers.
2. Reset the steering trim to
Neutral position.
3. Tighten the Servo Saver’s
spring and E-clip or replace if
needed.
1. Check if the servo plug is
connected to the receiver in
correct polarity. Make sure the
receiver’s pins are not bent
and the plug is inserted
properly.
2. Adjust the remote’s ST.D/R
button by pressing the +
button until the green light
stops flashing. It means that
the steering angle is set to
100%.
3. Try to insert the servo plug
in CH4 of the receiver and see
if the steering responds on
this channel. If yes, the pins on
CH1 could be broken and the
receiver needs replacement.
4. If inserting on the other
channel does not fix the issue,
please replace the servo.
Make sure the batteries are
fully charged and rebind the
remote and RC car.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION