Lacunza Vulcano 7T E/E, Инструкция

Страница: 6 / 32

5
•
2.- INSTRUCTIONS FOR THE INSTALLER
2.1. User notice
All local and national building regulations
must be adhered to for the installation of this
cooker.
A poorly installed cooker can cause serious
incidents such as fire, chimney fire, etc.
The appliance must be insulated and flued as
per manufacturer’s instructions and Building
Regulations.
Failure to comply with the instructions will
invalidate
your warranty. The
manufacturer’s liability is limited to the
appliance only.
2.2. Site for installation:
Ventilation:
In order for the appliance to operate correctly,
it is important to ensure that there is sufficient
air supply to the room
An additional air vent will be required to be
installed into the rooms equipped with a MVC
(Mechanical Ventilation Control) this inhales
and renews the air. In this case the room is
slightly depressed and it is necessary to install
an outdoor air intake, not sealed, of a section
of at least 90 cm
2
.
Hearth:
Make sure that the floor is able to take the full
weight of the cooker. If the floor cannot, it
will need to be strengthened prior to the
installation. The floor will need to be made of
non-combustible
materials. A non-
combustible hearth of a least 12mm thickness
is required 300mm in front of the appliance.
Adjustable height legs:
The cooker has a standard height of 850mm
but the legs height can be adjusted up to
900mm. The leg height can only be adjusted
prior to installation of the cooker.
To adjust the leg height, remove the side
panel which is secured with 4 screws (figure
15). This will give you access to the legs
which can then adjusted using a 19mm
spanner (figure 16).
Figure
No.3
- Minimum installation
separation from combustible materials
Distance
A
Distance
B
Distance C
Vulcano 7T E3 E/E
200 mm 200 mm 200 mm
Figure
No.4- Minimum installation
separation from combustible materials with
side insulation modules
Distance
D
Distance
E
Distance
F
Vulcano 7T E3 E/E 0 mm 0 mm 200 mm