Lacunza Tarbes, Инструкция

Страница: 9 / 28

INSTRUCTIONS FOR THE INSTALLER 8
2.
Disassembly of the rear bottom cover
and the top connection collar :
1. First remove the vermiculite baffles
plates of the combustion chamber
(see section 3.8).
2. Remove the cover (10) from the
back wall by removing the nuts (6)
and the clamping brackets (7).
3. Remove the cover (10) and the seal
(9). Check that the sealing tape on
the contact surface is not damaged.
Replace the sealing tape if it is
damaged.
4. Disasemble the connecting collar (2)
by undoing the bolts (1).
5. Remove the connection collar (2),
the seal (3) and the materials
supplied (1,4,5). Check that the
sealing tape on the contact surface
is not damaged. Replace the sealing
tape if it is damaged.
Figure No.6 - Disassembly of the rear
bottom cover and the top connection
collar
Assembly of the cover at the top and
the connection collar at the rear .
1. Assemble the cover (1) and the seal
(2) with the materials supplied
(3,4,5).
2. Fit the connecting collar (9), the seal
(12) on the back wall with the
attachment materials (6,7,8).
3. Replace the vermiculite baffle inside
the combustion chamber.
Figure No.7 - Assembly of the cover at the
top and the connection collar at the rear
2.3.7. Preparing the outside air conection
On this model, it is possible to pipe air
to the appliance for combustion straight
from outdoors. We recommend that, if
possible, air be drawn from outdoors for
combustion via a non-closable pipe with a
diameter of 80mm leading to the nozzle on
the bottom-front of the appliance.
If the tube is straight, it can have a
maximum of 12 meters in length. If you use
accessories like elbows, you must subtract
the total length (12 meters) 1 meter for
each accessory used.