Lacunza CM-300, Инструкция

Страница: 9 / 28

INSTRUCTIONS FOR THE INSTALLER 8
2.
2.3.4. Height adjustment and levelling the
appliance
The appliance must be perfectly level,
horizontally and vertically, both at the
front and on the sides (use a spirit level).
2.3.5. Placement tubes covers and top
finish
The chimney is equipped with a tube cover
and an upper finish to make the
connection with the ceiling (maximum
height 3 meters).
Once the stove is placed in its location and
the flue pipe has been connected, we will
install the tube cover.
1º If the ceiling height is between 2.5m
and 3m, the two whole pieces are placed,
but if the ceiling height we have is between
2.3m and 2.5m, the lower part of the tube
cover must be cut by the half-cut marks.
Figure No.6 - Half-cut marks of the lower tube
cover
Place the handle of the draught damper
flapper valve in a vertical position and fit
the bottom of the tube cover, inserting the
4 screws that the tube cover brings, into
the bell holes.
Figure No.7 - Lower tube cover positioning
3.- Position the upper part of the tube
cover and after marking on the ceiling,
place 4 anchoring plugs. Then we hold this
piece to the ceiling with 4 screws.
IMPORTANT:
The ceiling has to support the weight of
the upper tube cover, if the ceiling is not
able to support it, place it in such a way
that all the weight does not fall on the
ceiling, such as screwing the two parts of
the tube cover together so that everything
weight does not fall on the ceiling.
Figure No.8 - Screw the upper tube cover to the
ceiling
VERY IMPORTANT: Do not cover the grilles of
the the upper part of the tube cover; if
necessary, cut the lower part of the tube cover