LACAVA
5
Installation Instructions/Instrucciones de Instalación
WAL L
Level 1
(most soap)
Level 2
Level 3
Level 4
(least soap)
Prime button
soap quantity
adjustment access
wall
2. Fill the soap bottle with liquid soap (make sure soap
viscosity is within recommended range).
3. Install the soap bottle into the mount/pump. Then
press and hold the Prime button until soap exits the
spout.
4. Place hands under spout and test the dispenser’s
operation.
Adjust Quantity Dispensed
1. Remove the rubber plug in order to acces the
adjustment switches.
2. Remove the material covering the switches so
they can be moved.
3. Move the switches to the desired level of soap
quantity.
4. Push the rubber plug back into the access hole.
rubber plug
1. With all components mounted plug in the electricity
sources and use the QUICK CONNECT to link the soap
line. Press the end of the QUICK CONNECT while sliding
the line in until it seats.
IMPORTANT:
DO NOT ATTEMPT TO
TIGHTEN OR LOOSEN
FITTING AT PUMP
(FACTORY INSTALLED
AND SEALED).
Quick
Connect
press and hold down
to slide hose in or out
Sensor Range Adjustment
1. Place magnet in close proximity to the sensor until red light starts blinking
2. While the red light is pulsating, place and hold hands in the distance
where the sensor will be activating water to flow. Factory setting is 3”.
3. When the light stops blinking, the sensor is set to the new distance.
2”-12”
(5-30cm)