INSTALLER’S MANUAL
CORMATIN
Page 12 of 40
ELECTRICITY
It is hazardous to put the appliance into service without connecting it to suitable ground.
No liability can be accepted for accidents resulting from non-compliance with this requirement or incorrect grounding.
Connect the equipotential bonding terminal (
N
, Figure 25).
Before connection, check that the
:
Mains voltage is compatible with the appliance’s rated
voltage and thermal output.
Connection :
Use a 3-wire grounded cord rated for 13 A or 4-wire rated for 30 A 125 / 250
VAC, type SRD, SRDT, S, SO or ST.
Where local Codes do not permit grounding through neutral, use a 4-wire power
supply cord or “pigtail” kit. Cord must be agency approved for use with
household ranges.
Remove access door
O
(Figure.25, gas oven range) or
P
(Figure 26, 4 electric
oven range).
Connect to terminal block in accordance with figure 28.
Secure the cable by means of cable clamp, item
Q
(Figure 27).
Refit access door
THE APPLIANCE WHEN INSTALLED, MUST BE
ELECTRICALLY GROUNDED IN ACCORDANCE
WITH THE LOCAL CODES OR The National Electrical
Code, ANSI/NFPA 70-1996 or latest edition.
ALL WORK ON OR REPAIR OF AN APPLIANCE
MUST BE CARRIED OUT BY A QUALIFIED
INSTALLER.
IMPORTANT
Fig 26
O
N
Fig. 25
