Bi-pin Fluorescent Lamp Installation /Verification
Prior to applying power to the unit, verify that all lamps are properly installed and fully engaged in
the lamp holders.
Proper lamp engagement is achieved by rotating the lamp 90° from its insertion position until it
"snaps" or "clicks" into place.
Visual verification can be made on units without safety shields by using the identification mark on the
end of the bulb. Properly installed bulbs will have the mark centered between the "halves" of the
lamp holder.
On units with shields, the identification mark cannot be seen. Physically verify that the lamp has been
rotated and locked into place.
See pictures below.
Caution: Improperly installed lamps may cause damage to the lighting circuit.
Beverage-Air shall have no liability whatsoever for equipment or component failures or other
damages or losses which arise as a result of improper installation.
809-067A
