Labelmate RRC-400, Руководство пользователя

Страница: 5 / 18

FIG. 1
FIG. 2
FIG. 3
Set Screws
“ Flat ” on
Motor Shaft
Page 5
GETTING STARTED
Step 1: Install Exterior Roll Guide Shafts and Brackets (Recommended)
•
The Guide Bracket is used to maintain a flush outer roll edge.
•
The Guide Bracket Shafts are mounted in the two upper corners of the unit. (FIG. 1)
•
Lay the counter on its back so the inside is visible. (FIG. 1)
•
Remove hardware from the Shafts and install them in the upper corners of the unit using the M13 bolt
and nut on the inside of the machine as shown.
(FIG. 1 & FIG. 2)
Step 2: Install Core Holders
•
With your hand, turn each motor shaft so that the flat of the shafts face the nearest outside edge of the
machine.
(FIG. 3)
•
Slide the core holder assemblies onto the motor shafts. (FIG. 14 & FIG. 15)
•
Tighten both set - screws in the core - holder assemblies firmly onto the flat part of the motor shafts using
the provided Allen wrench until they are tight. (FIG. 3)
•
Both the “ Quick - Chuck ” and ACH Core - Holders are installed identically.