SET-UP AND USE (Refer to Figures 1 - 5 Next Page)
1. Make sure the Power Switch is in the center “OFF” position.
2. Set your Label Dispenser in place and plug the cord from the Power
Supply Module into the Power Input Jack on the rear of the Unit.
3. Connect the Power Supply Module to a suitable AC power source.
4. Place your roll of labels onto the white Supply Shaft “
A
” and slide the white
plastic Guide Rings “
B
” to the width of your label web and tighten the
thumb screws. The Label Web can be adjusted from side to side as
required to ensure that the labels line-up with the reflective Sensor “
J
”.
5. Thread the label web under Guide Rod “
C
” and then between the Stripper
Bar “
E
” and Guide Rod “
D
” as illustrated on the diagram label on the unit.
6. Pull the label web UNDER the Stripper Bar “
E
” and over Guide Rod “
F
”.
Slide the Aluminum Guide Ring “
G
” into position to maintain the web
alignment, and tighten the thumb-screw.
7. Loosen the white plastic Key “
I
” in the Take-up Shaft by pulling it out as
shown in
Figure 2
, and insert the leading edge of the liner into the slot
between the Key and the Shaft “
H
” as shown in
Figure 3
.
8. Pinch the liner tightly between the Shaft and the Key by lifting and
pressing the Key forward firmly as shown in
Figure 4
.
9. Rotate the angle of the Sensor “
J
” by turning the black knob so that the
Sensor is pointing up at the bottom of the Stripper Bar “
E
”. Place the
Power Switch in the “LOW” position. Slowly rotate the Sensor down until
the label begins to advance. Continue to rotate the Sensor slowly until the
desired label length is protruding as shown in
Figure 5
.
10. Use the “HIGH” or “LOW” Switch settings to select the desired speed.
11.
IMPORTANT – Lift labels UP when removing them from the
Dispenser. Do not pull them to the side.
12. To remove the waste liner that accumulates on the Take-up Shaft “
H
”,
release the plastic Key “
I
” by pulling it out away from the machine, and
then slide the roll of waste liner off the Shaft.
13. If excess dust or dirt accumulates on the Label Sensor Eye the Dispenser
may not sense labels correctly. Use a cloth or paper towel dampened with
water to gently clean the Label Sensor.
Do not use any chemicals on the
sensor.
WARNING
This product is for indoor use only.
Not for use in wet locations.
Unplug unit before removing waste
material or performing any cleaning or
maintenance services.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
A
C
D
E
F
B
G
H
I
J