10
4.3.2) PASSWORD
To prevent changes in the work program of the door, you can set a password that must be entered each time you act on the N-DSEL
programmer.
To enable the password, do the following
:
1. Press the SET button for 5 second to enter the programming menù general
(see Diagram 1 in par. 4.3.1)
2. Press the F1 button five times to move to the submenu Password Manager.
3. Press the Enter button to enter the "Password Management".
PASSWORD MANAGEMENT
In this section are two passwords that can be used by the end user, the primary password and password service.
The technical password is reserved only to the technical personnel responsible for installation and maintenance.
PRIMARY PASSWORD (for the system's owner-user)
It is a 5-character password used by the user to prevent unauthorized persons from having access to N-DSEL programmer and change the
work program.
Using a primary password is optional and must be enabled by system's owner.
Default preset primary password is “A-A-A-A-A”.
WARNING!
When enabling the password, be very careful not to forget the access combination.
SERVICE PASSWORD (for user)
It is a 5-character password that the system's owner may divulge to persons to be authorized to use N-DSEL programmer.
The service password only allows changing the automatic door work program.
Default preset service password is “A-A-A-A-A”.
To change the service password, it is necessary to have access by primary password.
Use button to move the selection arrow downward, F2 button to move the arrow upward.
HOW TO CHANGE THE PRIMARY PASSWORD
Select “PRIMARY PASSWORD”
Press OK (F1) button.
Type the default preset primary password “A-A-A-A-A” by pressing 5 times on A
button.
Type the new primary password, selecting a combination of 5 characters from the
letters A-B-C-D.
