3
NOTICE
Remove all items from the packaging and ensure that all parts
and accessories are included in the kit. Any claims for damage
or shortage in shipment must be filed immediately against the
transportation company by the consignee.
■
Tools Required (Not Included):
- 7 mm and 10 mm wrench
- Phillips head screwdriver
- Rubber Mallet
- Drill and proper bolts or anchors for attaching to the
floor(refer to local codes).
■
Preparing for Installation:
Determine the best area to install the rack system.
Ensure the location meets all code requirements,
and that all safety and clearance requirements for
the appliance(s) to be mounted to the rack are met,
refer to installation manual.
■
Installing the Rack System:
1.
Move the rack components to the installation
location. Ensure you have all the components for the
installation.
2. Set the base feet in the installation location. Verify
finished installation clearances will meet the service
clearance requirements of the appliance(s) to be
mounted on the rack.
3. Use a Phillips Head Screwdriver and eight(8) M6
Self Tapping Screws to loosely install the four(4)
Angle Supports to the two(2) Base Feet. See Figure
1(a).
Installer
- Read all instructions in this manual before
installing. Perform steps in the given order. Obey all local
codes. Obtain all applicable permits before installing this rack
system.
NOTE:
Install all components in such a manner that does not
reduce the performance of any fire rated assembly.
User -
These instructions are for use only by a qualified
heating installer / service technician.
FAILURE TO ADHERE TO THE GUIDELINES ON THIS PAGE
CAN RESULT IN SUBSTANTIAL PROPERTY DAMAGE,
SEVERE PERSONAL INJURY, OR DEATH.
WARNING
This rack system must be properly anchored and secured to
the floor BEFORE mounting appliances on it. Failure to follow
these instructions could result in substantial property damage,
severe personal injury, or death.
WARNING
Carefully consider installation when determining rack location.
Please read the entire appliance installation manual before
installing this rack. Failure to properly take factors such as
appliance venting, piping, condensate removal, and wiring into
account before installation could result in wasted time, money,
and possible property damage and personal injury.
Do not attempt to overtighten any of the bolts as this may
damage the threads and prevent the bolts from turning.
CAUTION
Figure 1(a) - Installed Angle Support
4. Insert the vertical posts between the loose angle
supports. Before tightening the M6 self tapping
screws, insert one M10 Hex Bolt with two M10
washers and M10 Hex Nut as shown in figure 1(b).
Once the M10 bolt is tightened ensure all M6 Self
tapping screws are tightened.
5. Align the Base support on each side of the vertical
posts with the six holes in the vertical post and base
foot. Using one M10 Hex bolt, Two M10 washers,
and one M10 Hex nut for each of the 6 holes.
Tighten the 6 M10 bolts for each vertical post.
Figure 1(b) - Installed Angle Support
