2
SET UP:
Note: This weather station receives only one outdoor transmitter.
Do not mix old and new batteries. Do not mix alkaline, standard, or rechargeable batteries.
1. First, insert the batteries into the temperature transmitter.
(see “
Install and replace batteries in the
temperature transmitter
“).
2. Within 30 seconds, insert the batteries into
weather station (see “I
nstall and replace batteries in the
weather station
”). Once the batteries are in place, all segments of the LCD will light up briefly. Then
the time (default 12:00) and the weather icon will be displayed. If these are not displayed after 60
seconds, remove the batteries and wait for at least 60 seconds before reinserting them.
3. After inserting the batteries, the weather station will start receiving data from the transmitter. The
outdoor temperature and the signal reception icon should then be displayed on the weather station. If
this does not happen after 3 minutes, the batteries will need to be removed from both units and reset
from step 1.
4. In order to ensure successful 915 MHz transmission, this should under good conditions be a distance
no more than 330 feet/100 meters between the final position of the weather station and the
transmitter (see notes on “
Mounting
” and “
915 MHz Reception
”).
INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The weather station uses 2 x AA, IEC LR6, 1.5V batteries. When batteries need
to be replaced, the low battery icon will appear on the LCD. To install and replace
the batteries, please follow the steps below:
1.
Lift up the battery compartment cover.
2.
Insert batteries observing the correct polarity (see marking).
3.
Replace compartment cover.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The temperature transmitter uses 2 x AAA, IEC LR3, 1.5V batteries. To install and replace the batteries,
please follow the steps below:
1. Remove the battery compartment cover at the back of the transmitter.
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery compartment cover on the unit.
Note:
When changing batteries in any of the units, all units need to reset by following the
setting up procedures. This is because the transmitter at start-up assigns a security code
and this code must be received and stored by the Weather station in the first 3 minutes of power supplied
to it.
BATTERY CHANGE:
It is recommended to replace the batteries in all units regularly to ensure optimum accuracy of these units
(Battery life see
“Specifications”
).
Please participate in the preservation of the environment. Return used batteries to an
authorized depot.
