53
will display the data measured by the internal sensor of the second dual channel transmitter.
Yet the probe data from the second transmitter will not be displayed on the Weather Station.
7.
Once the remote temperature has been received and displayed on the Weather
Station, the DCF time code reception is automatically started. This takes typically
between 3-5 minutes in good conditions.
IMPORTANT:
•
Transmission problems will arise if the setting for additional transmitters is not
followed as described above. Should transmission problems occur, it is necessary to
remove the batteries from all units and follow the set-up from step 1.
•
If after 10 minutes, the Atomic auto-set time (DCF time) has not been received, press
the SET key to manually enter a time initially.
•
Daily DCF reception is done at 02:00 and 03:00. If the reception at 03:00 is not
successful, then at 04:00 and 05:00 and 06:00 there are other tries, until one is
successful. If the reception at 06:00 is still not successful, then the next try takes place
at 02:00 next day. (Please refer also to notes on “
DCF-77 Radio Controlled Time
”
and “
Manual Time Setting
”).
