Battery compartment
Socket for
Adaptor
5. Setting up
Firstly, choose to use the adaptor (included in this set) or bat-
teries for operation. Both these methods allow for operation of
using wireless 433MHz transmission or cable connection be-
tween the base station and the sensors and setting up for both
methods is as follows:
Base Station:
Setting up using batteries:
Important: To avoid operating problems, please take note of bat-
tery polarity if inserting any batteries
1) Pull away the rain cover of the thermo-hygro sensor to reveal the
three sockets (for the wind sensor, rain sensor and the base sta-
tion)
2) Connect the attached cables of wind and rain sensors to the
corresponding sockets of the thermo-hygro sensor by clicking
them into place
3) Open the battery cover of the thermo-hygro sensor located below
the three sockets and insert 2 x AA, IEC LR6, 1.5V batteries and
close the cover
4) Open the base station’s battery cover located at the back of the
unit and insert 3 x AA, IEC LR6, 1.5V batteries into the battery
compartment and close the battery cover
Socket for
Thermo-Hygro
Sensor
PC COM
Port
Battery
Compartment
Battery Cover
Thermo-Hygro Sensor
Sensor sockets
Sensor sockets
