15
Next press and hold the
“SET”
key for at least three seconds. You
will see then that the values will reset to the current temperature
and corresponding time.
B.
Multiple Remote Temperature Sensors
The WS-7394U is able to receive signals from 3 different remote
sensors. These extra remote sensors can be purchased through the same
dealer as this unit. A TX4U will monitor the temperature and humidity,
a TX3U will monitor temperature and display the temperature on its
LCD, a TX3UP will monitor the temperature via a probe for measuring
soil or water temperatures and a TX6U will monitor the temperature
only.
Note: When setting up multiple units it is important to insert batteries
first into all the remote sensors, and in numeric sequence. Second
install batteries into the indoor weather station. Transmission
problems will arise if this is not done correctly and if the total time for
set-up exceeds 6 minutes
1.
Set Up of Multiple Units
a.
It is necessary to remove the batteries from all units currently
in operation.
b.
Remove the battery covers to all remote sensors.
c.
Place all remote sensors in a numeric sequential order.
d.
In sequential order, install batteries following the same battery
installation procedures seen in Detailed Set-Up Guide section
of this manual.
e.
Install batteries into the indoor weather station.
f.
Follow the Detailed Set-Up Guide for programming and
operating instructions.
2.
Viewing and Operating with Multiple Remote Sensors
a.
To view the temperature of a different remote sensor press and
release the
“CH”
button. A shift from one “boxed” number to
the next should be observed in the OUTDOOR LCD.
b.
The minimum and maximum temperature of the additional
remote sensor can be displayed by pressing the
“OUT/+”
button.
c.
To reset the minimum and maximum temperature readings
press and hold the
“SET”
button for 3 seconds and that
temperature record for that remote sensor will be reset only.
