7
DETAILED SET-UP GUIDE
BATTERY INSTALLATION
A.
Remote Thermo/hygro Sensor
1.
Pull the cylindrical rain cover off the remote
thermo/hygro sensor.
2.
Remove the battery cover (located on the backside of
the remote thermo/hygro sensor, above the mounting
post and bracket).
3.
Press the arrow and slide the battery cover off.
4.
Observing the correct polarity install 2 AA batteries.
5.
Replace battery cover, and place rain cover snugly
onto the remote thermo/hygro sensor.
B.
Indoor Weather Station
1.
Remove the battery cover. To do this, insert a solid
object in the space provided at the lower-central
position of the battery cover, then push up and pull
out on the battery cover.
2.
Observe the correct polarity, and install 2 AA
batteries.
3.
Replace the battery cover.
Note: Immediately after the batteries have been installed, each
LCD (Liquid Crystal Display) will flash, and a tone will sound.
Within a few seconds the indoor temperature, indoor relative
humidity, and the weather icons (sun and clouds) will be displayed.
If these items are not displayed remove the batteries for 10 seconds
and reinstall. If the outdoor temperature is not displayed within
four minutes, remove the batteries from both units, wait 10
seconds, and reinstall. The time will show -:-- and start searching
for the signal. If it successfully receives the time signal (reception
Battery
Cover
