Add-On Sensors
SENSORS
24
Adding Sensors to Your Display
2.
Install batteries into your sensor. If the sensor has
a
TX
button, press it to force a transmission signal.
This button is usually located in or near the sensor’s
battery compartment. The LED light on the sensor
will flash once.
3.
Your sensor should connect within the next three
minutes. The Sensor Reception Indicator ( ) will
appear solid when a sensor is connected.
Inside of Water Leak Sensor*
Top of Water Leak Sensor*
* Water Leak Sensor shown as example, sensor not included
1.
Hold the
EXTRA SENSOR ( )
button until the
Sensor Reception Indicator ( ) starts to animate.
Tap the
EXTRA SENSOR ( )
button to switch
between pressure and add-on sensor readings,
or select the Auto-Scroll option to cycle through
all available pressure and sensor data.
Tap the
EXTRA SENSOR ( )
button until
AUTOSCROLL appears on the display.
Viewing Add-On Sensor Data
Programming the Auto-Scroll Option
To deactivate the Auto-Scroll option, tap the
EXTRA SENSOR ( )
button until the Auto-Scroll
Icon ( ) disappears. The display will stay on
your current selection.
The Auto-Scroll Icon ( ) located in the top left
corner will appear when active.
