4
DETAILED SET-UP GUIDE
I. BATTERY
INSTALLATION
A. REMOTE TEMPERATURE SENSOR
1. Remove the mounting bracket. The
bracket snaps on and off easily.
2. Remove the battery cover, by sliding the
cover down.
3. Observing the correct polarity install 2 AA
batteries. The batteries will fit tightly (to
avoid start-up problems make sure they do
not spring free).
4. Replace the battery cover by sliding upwards. Be sure battery
cover is on securely.
B. INDOOR THERMO STATION
1. Remove the battery cover. To do
this, insert a solid object in the space
provided at the lower-central
position of the battery cover, then
push up and pull out on the battery
cover.
2. Observe the correct polarity, and
install 2 AA batteries.
3. Replace the battery cover.
Note:
Immediately after the batteries have been installed, the
LCD (Liquid Crystal Display) will flash, and a tone will sound.
Within a few seconds the indoor temperature, indoor relative
humidity, will be displayed. If not, remove batteries for 10
seconds and reinstall. If the outdoor temperature is not displayed
within four minutes, remove batteries from both units, wait 10
seconds, and reinstall making sure to install batteries into the
remote temperature sensor first. The time will show -:-- and start
searching for the signal. If it successfully receives the time signal
(usually at night), it will display the correct time (default time-
Battery
compartment
Battery
Cover
