La Crosse Technology 616-146v2, Часто задаваемые вопросы

Страница: 9 / 10

La Crosse Technology, Ltd. www.lacrossetechnology.com/support Page 9

Rotate Projection Image: When you place the clock and the projection looks upside down or
sideways, you can rotate the image to make it readable.

Press and release the PROJECTION button to rotate projection image 90 degrees.

Press and release the PROJECTION button again to rotate another 90 degrees.

Change Projection Mode: Hold, then release the PROJECTION button to switch projection modes.
You will need to watch the projection image to view the changes.

Time and Outdoor Temperature: alternate every 5 seconds (default)

Time : Hold and release PROJECTION button

Outdoor Temperature: Hold and release PROJECTION button again

Projection Intensity: The brightness of the projection is adjustable in three settings: High, Low, and
OFF.

HIGH: The projection is defaulted to HI (brightness) when the A/C adapter is in use.

LOW: Press and release the SNOOZE/LIGHT button to dim the brightness of the projection.

Press and release the SNOOZE/LIGHT button to return projection to full strength (HIGH).
Note:
When the Adapter is NOT in use, the High/Low feature is not available.
Note:
When you adjust the projection, you adjust the backlight at the same time.
Battery Power:
Press and release the SNOOZE/LIGHT button to show the projection for 10 seconds.
The projection will not stay on when operation on battery power only.
Daylight Saving Time

Dependent on your location, position of the clock in your home, and atmospheric interference, it may
take up to 5 nights for the change from Daylight Savings Time to Standard Time and vice-versa to
occur.

Check for a WWVB Tower Icon showing on your Clock. The tower icon indicates you have received
the WWVB signal from Ft Collins CO in the past 24-hours.

Check that the clock is in the correct Time Zone .

Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not change.

Check for fresh batteries . Without proper batteries, the antenna will have a harder time picking up
the signal.

Position the Atomic Projection Alarm in a window ( with the front or back ) facing Ft. Collins, Colorado
and leave for up to five nights. If you do not have a window facing this direction, locate the Clock near
an outside wall and point the unit in this general direction.
No WWVB Tower Icon

The Atomic Projection Alarm has not received a WWVB time signal in the past 24-hours.

Position the Atomic Projection Alarm for better reception.

Hold the -/TIME button to send the Atomic Projection Alarm on a signal search at night.

Allow up to 5 nights to receive the time signal.
Projection alarm is dim
Explanation: Most projection alarms have a gray background. Place the projection alarm at eye level, to
determine if it is dim. Projection alarms that sit in the sunlight can develop a cloudy film over time.

This is generally a power related issue.

Batteries may be overpowered or underpowered. Remove batteries from projection alarm.

Press any button 20 times. Leave the projection alarm unpowered for 1-2 hours.

Install fresh alkaline batteries with correct polarity.