La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 8
Note:
When no buttons are pressed for ten seconds, the forecast station will save the last change and
default back to normal mode
Activate/Deactivate time alarm
In normal mode, press and release the ALARM button once to show alarm time.
Press and release the ALARM button repeatedly to turn ON/OFF alarm.
The alarm icon appears when alarm is active.
Note:
The alarm will ring for 2 minutes then turn off if no buttons are pressed.
Snooze Alarm
When the alarm sounds, press the HI/LOW/OFF
button to snooze the alarm for 10 minutes.
The snooze option can repeat three times.
The alarm icon will flash while the snooze feature is active.
Note:
while the alarm sounds press any button
except
the ALARM button to turn the alarm off.
USB Charge Port
Explanation:
The forecast station has an integrated USB charging port (on back) that will charge a
device when the forecast station is plugged into a power outlet.
Note:
This is a power-output charging port. It does not supply power to the projection alarm.
Connect your external device’s USB charging cable (not included) to the USB charging port.
Charging times will vary.
USB Power Output: 0.5A maximum current. Charge 0.5A devices or devices that are self-regulating.
Note:
Some USB cables are for data transfer only and cannot be used for charging. Make sure that the
USB cable you use will charge your device. Most USB cables included with mobile devices will work for
charging.
Note:
Many devices may require more power to charge than provided by this forecast station.
Projection not working
When operating on A/C power and no constant projection shows, yet it works when you press the
SNOOZE button please check:
ON/OFF:
Place your hand about 2'' from the projection lens. You should see a red dot. If not, hold
and release SNOOZE/LIGHT button once to check that projection was not accidently turned off.
A/C CORD:
The projection will continuously display if the A/C cord is attached correctly and the
projection is turned on.
Check that the A/C cord attached properly. Line up the cord and push it in the clock.
Once you are sure it is in correctly,
remove the batteries
. If the display goes blank, the A/C cord
needs adjustment.
Check that the outlet or power strip has power.
Note:
When you
adjust the projection, you adjust the backlight
at the same time.
IMPORTANT:
When operating on A/C power,
the backlight, projection and USB charging port
will
turn off while the Projection Alarm searches for the WWVB signal, to avoid interference. The backlight
and projection will return after the 2-10 minute search (which occurs during the late night or early morning
hours). The USB charging port will then resume working.
Projection Adjustments
When operating on A/C power the projection will display constantly unless projection is turned off or when
the clock is searching for WWVB signal.
Operating on a/c power:
Projection is displayed constantly when operating on A/C power, unless manually shut off.
