La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 8
2. MINUTES: The
Minutes
will flash, use the ARROW buttons to set the minutes, and press TIME
ALARM button to confirm.
3. Press the SETTINGS button to return to normal mode.
Note:
When no buttons are pressed for ten seconds, the projection alarm will save the last change and
default back to normal mode
Activate/Deactivate time alarm
In normal mode, press and release the TIME ALARM button once to show alarm time.
Press and release the TIME ALARM button repeatedly to turn ON/OFF alarm.
The alarm icon appears when alarm is active.
Note:
The alarm will ring for 2 minutes then turn off if no buttons are pressed.
Snooze Alarm
When the alarm sounds, press the HI/LOW/OFF
button to snooze the alarm for 10 minutes.
The snooze option can repeat three times.
The alarm icon will flash while the snooze feature is active.
Note:
while the alarm sounds press any button
except
the TIME ALARM button to turn the alarm off.
Projection not working
Projection only shows when SNOOZE/LIGHT button is pressed:
Check the Projection ON/OFF switch, to be sure it is in the ON position.
Check that the a/c cord is properly plugged in. Line it up and push it in. Once you are sure it is in
correctly,
remove the batteries
. If the display goes blank, the a/c cord needs adjustment.
Projection Adjustments
When operating on A/C power the projection will display constantly unless projection is turned off or when
the clock is searching for WWVB signal.
Operating on a/c power:
•
Projection ON/OFF:
Use the PROJECTION ON/OFF
slide switch
on the back of the clock to turn
the projection off when operating on a/c power.
•
Rotate Projection:
Press and release the PROJECTION/DIRECTION button to rotate projection
image 180 degrees as viewed on the wall or ceiling.
•
Focus Projection:
Use the focus wheel on the projection arm to adjust the clarity of the
projection on the wall or ceiling.
•
Time/Outdoor Temperature Projection:
The projection will alternate between time and
outdoor temperature every 5 seconds. This projection cannot change to just time or just
temperature.
The projection will always alternate.
Operating on battery power only:
Press and release the
SNOOZE/LIGHT button on top of the Atomic Projection Alarm to
show the
projection for 5 seconds.
Note:
Projection will not display constantly when operating on battery power.
Daylight Saving Time
Dependent on your location, position of the clock in your home, and atmospheric interference, it may
take up to 5 nights for the change from Daylight Savings Time to Standard Time and vice-versa to
occur.
Check for a
Tower Icon showing on your Clock. The tower icon indicates you have received
the WWVB signal from Ft Collins CO in the past 24-hours.
Check that the clock is in the correct
Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not change.
Check for fresh
. Without proper batteries, the antenna will have a harder time picking up
the signal.
