PROJECTION:
Battery Power:
Press and release the
SNOOZE/LIGHT button on top of the
projection alarm to
show the projection for 5 seconds.
Note:
Projection will not display constantly when operating on battery power.
A/C Power
: Projection is displayed constantly unless turned off.
Projection ON/OFF:
Use the PROJECTION ON/OFF
slide switch
on the back of
the clock to turn the projection off when operating on a/c power.
Rotate Projection:
Press and release the PROJECTION/DIRECTION button to
rotate projection image 180 degrees as viewed on the wall or ceiling.
Focus Projection:
Use the focus wheel on the
projection arm to adjust the clarity of the projection on
the wall or ceiling.
Time/Outdoor Temperature Projection:
The
projection will alternate between time and outdoor
temperature every 5 seconds.
This is not adjustable
.
IMPORTANT:
When operating on a/c power, to avoid interference, the projection
will turn off while the Projection Alarm searches for the WWVB signal. The
projection will return after the 2-10 minute search which occurs during the late night
or early morning hours.
POSITIONING THE OUTDOOR TRANSMITTER:
The remote temperature transmitter should be mounted vertically to avoid damage.
Place both units in the desired shaded locations, and wait approximately 1-hour
before permanently mounting the transmitter to ensure that there is proper
reception. The outdoor temperature transmitter is water resistant, not waterproof
and should not be placed anywhere it will become submerged in water or subject to
standing water or snow.
Wall Mount:
Choose a location for the transmitter that is within range of the Atomic Projection
Alarm and under an overhang for accuracy.
Option 1:
Install one mounting screw (included) into a wall leaving
approximately ½ of an inch (12.7mm) extended.
Place the transmitter onto the screw, using the hanging hole on
the backside.
Gently pull the transmitter down to lock the screw into place.
Option 2:
Insert the mounting screw through the front of the sensor and into the wall.
Tighten the screw to snug (do not over tighten).
To achieve a true temperature reading, mount where direct sunlight cannot reach
the outdoor transmitter. Mount the outdoor transmitter on a North-facing wall or in
any well shaded area. Under an eave or deck rail work well. The maximum
transmitting range in open air is over 200-feet (60 meters). Obstacles such as
walls, windows, stucco, concrete, and large metal objects can reduce the range.
Place the transmitter at least 6 feet in the air to improve signal transmission.
POSITIONING THE PROJECTION ALARM:
The Atomic Projection Alarm should be placed near an exterior wall with the front or
back facing toward Ft. Collin Colorado for best WWVB reception. The display
should be six feet from other electronics or wireless devices in order to best receive
the outdoor temperature transmitter signal.
LOW BATTERY:
When this icon appears in the indoor (IN) reading section, replace the batteries
in the Projection Alarm.
When this icon appears in the outdoor (OUT) readings section, replace the
batteries in the outdoor transmitter.
CARE AND MAINTENANCE:
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Standard, Lithium or Rechargeable Batteries
Do not expose the Projection Alarm to extreme temperatures, vibration or shock.
Keep Projection Alarm dry.
Clean the Projection Alarm with a soft damp cloth. Do not use solvents or scouring
agents.
The Projection Alarm is not a toy. Keep it out of reach of children.
The Projection Alarm is not to be used for medical purpose or for public
information, but is determined for home use only.
The specifications of this Projection Alarm may change without prior notice.
Improper use or unauthorized opening of housing will void the warranty.
If the Projection Alarm does not work properly, change the batteries and/or check
the a/c cord connection.
SPECIFICATIONS:
Indoor
:
Temperature Range:
+32°F to +122°F (0°C to 50°C)
Accuracy:
+/- 2 degrees Fahrenheit
Interval:
About every 30 seconds
Outdoor
:
Temperature Range:
-40°F to 140°F (-40°C to 60°C)
Alkaline Batteries: -20°F to 140°F (-28.8°C to 60°C)
Lithium Batteries: -40°F to 140°F (-40°C to 60°C)
Temperatures below - 20°F (-28.8°C)
require Lithium batteries in the outdoor sensor.
Distance:
Over 200 ft. (60 meters) RF 433MHz (open air)
Interval:
About every 30 seconds
Power:
Projection Alarm:
5-volt a/c power adapter (included)
Optional 3-AAA, IEC, LR3 batteries (not included)
TX141 Transmitter:
2-AA, IEC, LR6 batteries (not included)
Battery Life:
TX141 Transmitter
Battery Life:
Battery life is over 24 months when using reputable
battery brands for both Alkaline and Lithium batteries
Projection Alarm
Battery Backup:
Battery life is over 12 months when using the AC
adapter for primary power
Dimensions:
Projection Alarm: 7.09" x 3.62" x 2.87" (180 x 92 x 73mm)
TX141 Transmitter: 1.57" x 0.79" x 5.12" (40 x 20 x 130mm)
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited warranty on this product
against manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on
products purchased and used in North America and only to the original purchaser of
this product. To receive warranty service, the purchaser must contact La Crosse
Technology, Ltd for problem determination and service procedures. Warranty
service can only be performed by a La Crosse Technology, Ltd authorized service
center. The original dated bill of sale must be presented upon request as proof of
purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized
service center.
La Crosse Technology, Ltd will repair or replace this product, at our option and at no
charge as stipulated herein, with new or reconditioned parts or products if found to
be defective during the limited warranty period specified above. All replaced parts
and products become the property of La Crosse Technology, Ltd and must be
returned to La Crosse Technology, Ltd. Replacement parts and products assume
the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse
Technology, Ltd will pay all expenses for labor and materials for all repairs covered
by this warranty. If necessary repairs are not covered by this warranty, or if a
product is examined which is not in need or repair, you will be charged for the
repairs or examination. The owner must pay any shipping charges incurred in
getting the La Crosse Technology, Ltd product to a La Crosse Technology, Ltd
authorized service center. La Crosse Technology, Ltd will pay return ground
shipping charges to the owner of the product to a USA address only.
The La Crosse Technology, Ltd warranty covers all defects in material and
workmanship with the following specified exceptions: (1) damage caused by
accident, unreasonable use or neglect (including the lack of reasonable and
necessary maintenance); (2) damage occurring during shipment (claims must be
presented to the carrier); (3) damage to, or deterioration of, any accessory or
decorative surface; (4) damage resulting from failure to follow instructions contained
in the owner’s manual; (5) damage resulting from the performance of repairs or
alterations by someone other than an authorized La Crosse Technology, Ltd
authorized service center; (6) units used for other than home use (7) applications
and uses that this product was not intended or (8) the products inability to receive a
signal due to any source of interference.. This warranty covers only actual defects
within the product itself, and does not cover the cost of installation or removal from
a fixed installation, normal set-up or adjustments, claims based on
misrepresentation by the seller or performance variations resulting from installation-
related circumstances.
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR
INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES
ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT.
THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR
PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF
CHILDREN’S REACH.
This warranty gives you specific legal rights. You may also have other rights
specific to the State. Some States do not allow the exclusion of consequential or
incidental damages therefore the above exclusion of limitation may not apply to you.
For warranty work, technical support, or information contact:
La Crosse Technology, Ltd
2817 Losey Blvd. S.
La Crosse, WI 54601
The complete instruction manual is available at:
www.lacrossetechnology.com/616-143
Contact Support: 1-608-782-1610
Product Registration:
www.lacrossetechnology.com/support/register
Protected under U.S. Patents:
5,978,738, 6,076,044, 6,597,990
FCC Disclaimer:
This Device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) the device must accept any interference received, including interference that
may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO
OPERATE THE EQUIPMENT
All rights reserved. This handbook must not be reproduced in any form, even in
excerpts, or duplicated or processed using electronic, mechanical or chemical
procedures without written permission of the publisher.
This handbook may contain mistakes and printing errors. The information in this
handbook is regularly checked and corrections made in the next issue. We accept
no liability for technical mistakes or printing errors, or their consequences.
All trademarks and patents are acknowledged.
