L3 NARDA PMM 9010, Руководство пользователя

Страница: 51 / 108

Applications 7-3
7.1.2.2 Current Probe Current Probes may be Clamp-on Probes or Fixed-ring Probes.
Current Probes are used to measure differential or common mode RFI
currents. In some cases it may be important to make a distinction between
the two kinds of current flowing in a system.
RFI current measurements with Current Probes may be required, for
example, when measuring EMI from shielded lines or from complex wiring
systems, when finding interference sources among other sources in a
system, when performing compliance to some Standards, etc.
7.1.2.3 Voltage Probe Voltage Probes include Active Probes and Passive Probes.
Active Probe has a very high input impedance Zin > 100 K
Ω
// < 10 pF.
Passive Probe has a standard impedance Zin = 1,5 K
Ω
// < 10 pF.
Voltage Probe is used for measuring the unsymmetrical RFI voltage when it
is not possible to carry out measurement by interconnecting an Artificial V-
type Network. Such situation may occur, for example, when measuring on
lines on which only small loads are permissible (control and signal lines),
when measuring on a EUT (Equipment Under Test) which would not
operate correctly using V-type LISN or a DUT (Device Under Test)
requiring very high power supply current for which no V-type LISN is
available.
For diagnostic or design purposes on high impedance circuits, Voltage
Probe may be used to determine, for example, noisy components or
conductors that cause interference on CMOS PC boards.
Some Regulations give statements when Voltage Probe are to be used and
specify relevant setup and RFI voltage limits.
Fig. 7-2 Example of Test Setup for RFI Voltage Measurement