32
2.2 CONNECTING THE EQUIPOTENTIAL TERMINAL
Connect the oven to earth and insert it in the equipotential circuit.
The terminal used for this purpose is located at the rear of the oven, and is marked by the
international symbol shown in the figure.
2.3 CONNECTING THE POWER SUPPLY CABLE
1/A) Loosen the 4 screws holding the lid of the electrical board compartment and open it
1/B) Pass the power cable into the cable gland on the lid and compress it
3)
Connect the power cable to the terminals N - L1 - L2 - L3
1
A
B
2
3. PREPARATION OF THE OVEN FOR FIRST USE
3.1 INITIAL CLEANING
•
Remove the grill supports and/or baking pans from the inside of the cooking chamber.
•
Clean the oven before first use (see chapter on cleaning).
3.2 SWITCHING ON THE OVEN
ATTENTION
Before to proceed to the switch-ON of the equipment you have to verify as follow:
•
Of not having damp or wet hands
•
That the surface and the base of the oven are dry
•
That the oven door is closed; if this is not the case the safety micro will come into action by blocking the
operation of the oven. It will resume operation upon closing of the door.
After having carried out the above mentioned checks, the oven can be switched-on
.
7
Содержание VULCAIN-10
Страница 25: ...49 NOTES 24 ...
