L.T. Rich Products Z-Plug, Руководство пользователя

Страница: 16 / 31

The Diffuser adjustment allows the user to adjust the intensity of the spread pattern. A
small turn shifts the product placement on the impeller. This in turn balances the spread
pattern heavier to the left (back side ramp) or heavier to the right (front side ramp).
Adjustment is very sensitive, so multiple adjustments may be required.
*FOR MORE DETAILED INFORMATION, GO TO
WWW.SPYKER.COM*
(Diffuser cable & Hopper cable) (Hydraulic hopper motor)
(Knob adjusting dial) (Diffuser shown on underside of opening)
Your machine is equipped with the 120 lb Spyker model spreader. The hydraulic spreader
motor with the spreader motor control has the ability to vary spread widths from 4 to 25
feet. This depends on volume/density, particle size and rate of travel, and weather
conditions. The pattern can be increased or decreased while spreading depending on
needs. This allows you to spread and spray at the same time. A typical pattern is to
overlap fertilizer pattern back to the tire tracks and the spray pattern boom to boom.
To spray and spread at the same time: Set the spread pattern to twice the width of the
spray. For example a junior and intermediate model has a spray width of 8 feet. Set the
spreader width to 16 feet and spread back to the tire tracks. The spray pattern will match
boom to boom.
The spread things and feathers at the outer edges, eliminating sharp “edge to spread”
lines which cause stripes and streaks.
Determine a dial setting on the low side. If setting is too low, cover the area more than
one time. A higher setting can be used when a proven dial setting is established. Travel at
a constant speed.
Remember- Published dial settings are approximate only. Open the hopper door after the
spreader is turned on at operating speed.
Page 12