L.T. Rich Products Z-Plug, Руководство пользователя

Страница: 14 / 31

Pull the pin from the aerator front frame neck (it will be attached to the front frame of the
traction unit) and dismount the ball swivel from the pin (pull neck downward). Lower
front neck of the aerator head and position yourself back on the traction unit. Drive away
from the aerator head by turning either left or right (
turning to the right of the head
pictured on next page ) by turning the front of the traction unit in either direction. To
install head back on the unit, reverse the unit along the back of the tines. Once the rear
inside tire lines up to the center of the aerator head, slowly start turning unit over the
aerator head (make sure that you line up the ball swivel in the neck of the aerator and the
pull pin beneath the nose of the traction unit to make it easy for mounting)
SECTION 5 SPRAY/SPREADER SYSTEM (if equipped)
5.1 Valving
The Z-Plug can be equipped with a 30 gallon spray system with an 8’ breakaway spray
boom. If your unit has this attachment mounted on to your Z-Plug, here are some helpful
instructions on operating this system.
Periodically check the in-line filter for any debris in the screen. If debris is present, this
can create erratic pressure spikes and/or not allow the proper flow through system. After
clearing any debris, ensure that rubber seal remains intact and tighten in-line filter cap (if
not installed properly, this will allow air to get in the system and system will lose or not
create pressure).
The pump switch located on the control panel turns on the spray system pump. Once the
pump is turned on, the throttle valve is turned clockwise to increase pressure and/or
counter-clockwise to release pressure. The pressure can be read on the gauge (decreasing
pressure will increase agitation in the tank).
Opening the hose valve can operate 25’ coil hose for spraying out of the hand spray gun.
When coil hose not in use, be sure to turn valve off to prevent boom tips from dripping.
(Valve Open) (Valve Closed) (Throttle Valve/adjust pressure)
Page 10