K2 WST
®
enclosure
RIGGING MANUAL
VERSION 3.0
K2_RM_EN_3.0
w w w . l - a c o u s t i c s . c o m
1 8 / 76
4
SYSTEM SETUP
4.1
Ground-stacking
Final check
After the setup, always verify no yellow labels are visible on the front and on both sides of the array.
K2 enclosures on K2-CHARIOT and K2-JACK
Place a block of four K2 enclosures at the final position.
If a block is not already built
, refer to
PROCEDURE A
.
Preset the inter-enclosure angles.
Refer to
PROCEDURE B
.
Attach the K2-JACK stabilizers to the K2-CHARIOT.
Refer to
PROCEDURE C
.
If needed
, add one or two K2 enclosures to the stack.
Refer to
PROCEDURE A
.
Preset the inter-enclosure angles for the additional enclosures.
Refer to
PROCEDURE B
.
Push the topmost enclosure forward until all the automatic locks are in
place and verify that there is no yellow label visible.
If necessary
, change the position of the K2-CHARIOT rear rigging arm.
Refer to
PROCEDURE D
.
If necessary
, fine-tune the site angle of the stack by adjusting the height
of the stabilizers feet.
Refer to
PROCEDURE E
.
K2 enclosures on K1-SB
Stack as many K1-SB enclosures as necessary.
Refer to the
K1 rigging manual
to set up the K1-SB part of the array.
Position and attach a K2-BUMP on the K1-SB stack
Refer to
PROCEDURE L
.
Position and attach an upside down K2 on the K2-BUMP and add as
many K2 enclosures on top of the first one.
Refer to
PROCEDURE C.
