Kyoto Kagaku Physiko, Инструкция по эксплуатации

Страница: 28 / 29

25
DOs and DONʼTs
DOs and DONʼTs
DOs DONʼTs
● Operate the system under the designated
circumstances
● Do not disassemble or open electric or
precision components
Power input: AC100V～230V plus or minus 10％, 50Hz/60Hz
Temperature range: between 0 degrees C and 40 degrees C
(no congelation)
Relative humidity; between 0％to 80％ (no condensation)
*Connecting to power source outside of the designated
range may lead to fire.
● Safe disposition
● Handle with care
● When the electric parts get warm or produce
smoke, immediately turn off the power and
unplug from the power source
● Storage
● Handle the power plug and cord observing
following precautions
● Never wipe the product and components
with thinner or organic solvant
Donʼt mark on the product and components with pen or
leave any printed materials in contact with their surface.
The electric components are precision instruments.
Strong shocks or continuous vibration may cause breakages
of its internal structure.
Take at least 30 minutes shutdown, turning off the power,
every 2 hours.
When you use this model continually for a long time, it might
malfunction occasionally due to heat in some circumstance.
In this case, shut down the model for about 30 minutes and
restart.
Risk of shock.
Do not pour or spill water or liquid detergent over the
electric components, power cable and power plug.
Running the system while the electric components are wet
may create a shock hazard or a risk of fire.
Do not put the product close to fire. It may lead to discolor-
ation or deformation of the product as well as short circuit,
creating a risk of fire.
● Do not give shocks
● Do not wet the electric components
● Do not handle the power plug with wet hands
● No fire
● Do not run the system continuously over
2 hours
● Ink marks on the soft surface wonʼt be
removable
To avoid shoｒt circuit, do not run the simulator set above a
power receptacle.
Risk of fire. Contact your distributor or the manufacturer for
repair.
Handle the model carefully, like an actual patient. Excessive
force or impact may damage the product or result in
problems.
The materials for the models are special compositions of soft
resin. Please handle them with utmost care at all times.
For cleaning, wipe the model with water or soap water. If stain
persists, wipe with alcohol and place talcum powder on the
breast skin after dried.
Store the simulator at room temperature, away from heat,
moisture and direct sunlight.
Storage under the temperature above 50 degrees C may
reduce the performance quality of the simulator.
1. Clean the head of the plug periodically.
2. Plug in the plug to the outlet firmly to the end.
3. Always hold the plug when unplugging. Do not pull the cable.
4. Do not force to bend, twist the cable and avoid scratching
or cutting on it.
Failing to follow the above precautions can result in damage in
the plug and the cable, constituting risk of fire or shock.
Do not open up or disassemble the housing for electric parts
or precision components.
Refrain from opening up any lids, caps or covers for such
area, and never run the system while any of such covers are
open.
*Never disassembling the electric components, power plug
and cable as it may create a risk of fire, shock or injury.
Contact your distributor or the manufacturer for repair.