Kyosho Seabreeze 600, Инструкция по эксплуатации

Страница: 4 / 27

Some precautions need to be observed when building your
Kyosho kit to avoid problems:
1) Take time to read the instruction manual thoroughly.
2) Try to avoid working over a deep pile carpet. In the
event that a small part or screw should fall onto the
carpet, it would be difficult to find.
3) Place a mat or towel on the work surface where you will
be building the kit. This will prevent parts from rolling off
and will protect the work surface at the same time.
4) Avoid running the boat in very cold temperatures. Both
plastic and metal parts become brittle at low
temperatures. In addition, grease and oil become
thick, causing premature wear and poor performance.
5) Trial fit all parts to ensure proper fit before attaching
them permanently.
Remove all flashing from parts before assembly, as
shown in the example below.
6)
INCORRECT
Too much
removed.
Not enough
removed.
Do not
Use a sharp
hobby knife
to trim the
flash off.
remove the
flashing with
the cutter.
7) Important: Throughout the instruction manual
symbols are used to alert you to perform certain
procedures. A symbol guide is provided at the bottom
of each page to assist you.
THESE ARE NOT INCLUDED IN THE KIT
Phillips Screwdriver Hobby Knife (XACR4320)
Needle Nose Pliers
(XACR2680)
Wire Cutters
Tapered Reamer (KYOR1050)
(Used for drilling holes. A drill and
bits will also work fine.)
220 Grit Sandpaper
6-Minute Epoxy (Such as Great
Planes' Pro'" Epoxy GPMR6045)
Thick Cyanoacrylate Glue (Such
as Great Planes Pro'" CA+
GPMR6008)
Rubbing Alcohol
THESE ITEMS ARE REQUIRED TO RUN THE SEABREEZE 600
2-Channel Radio
(preferably with
watertight servos.
Batteries for the
radio system
(12 AA Batteries)
If you use Nickel Cadmium Batteries in the radio
system, the batteries are recyclable. At the end of
their useful life, under various state and local laws, it
may be illegal to dispose of these batteries into the
municipal waste system. Check with your local solid-
waste officials for details concerning recycling options
or proper disposal in your area.
IMPORTANT INFORMATION BEFORE BUILDING YOUR
SEABREEZE 600
Use the following diagram to
tie all the rigging knots.
4