2.2. Operating Procedures
2-7
On-line/Off-line Setting
By pressing the
ON LINE
key you can change the printer between the on-line state, in which it prints the data
it receives from the computer, and the off-line state, in which it stores the data for printing later.
1.
Make sure that the message display indicates
ý5HDG\
.
2.
Press the
ON LINE
key.
If the printer is on-line, it changes to off-line. If the printer is off-line, it changes back to on-line.
The ON LINE indicator lights when the printer is on-line.
Going off-line may or may not halt communication between the printer and computer, depending on details
of the current interface. While off-line, the printer continues to accept any data that arrives until the current
interface buffer is full, at which point it instructs the computer to stop sending data. Data stored while off-
line are printed when the printer is returned to the on-line state.
Canceling Printing
Perform the following procedure when you wish to cancel printing after it has begun.
1.
Check if the message
ý3URFHVVLQJ
is displayed in the message display.
2.
Press the
ON LINE
key to take the printer offline.
3.
Perform the necessary procedure on the computer to halt printing.
4.
Press the
CANCEL
key.
5.
The message
ý3ULQWý&DQFHO"
will appear in the message display and the interface to be canceled
will be displayed.
3DUDOOHO
6HULDO
2SWLRQý
(appears only when an optional interface is installed)
6.
Selecting the interface to cancel using the
+
or
–
key and then press the
ENTER
key. Printing from the
interface selected will be stopped.
A few pages may be printed even after the
CANCEL
key is pressed as remaining data received before the
CANCEL
key was pressed is printed.
The message
ý3ULQWý&DQFHO"ý&XUUHQWýMRE
will also be displayed when the
CANCEL
key is
pressed for the purpose of stopping the printing of status pages or font lists from the control panel. When
the
ENTER
key is pressed, the message
ý&DQFHOOLQJýGDWD
appears in the message display and
printing stops after the printer finishes printing the current page.
Press the
CANCEL
key again if you wish to stop the cancellation of printing.
Press the
ON LINE
key to put the printer back online to continue with other print jobs.
☛
Canceling data from the computer using the
CANCEL
key will restore temporary settings to their
default values. (The same status resulting from executing the PRESCRIBE 2e RES command.)
☛
It is impossible to cancel printing of just one side when printing in duplex mode using an optional
duplexer (DU-21).
