KYMCO UXV500, Руководство пользователя

Страница: 73 / 88

71
COOLING SYSTEM
Inspection
Your UXV500 has a liquid-cooled engine and periodically you
should inspect the level of the fluid in the coolant reservoir and
the external condition of the radiator.
Inspect and adjust the fluid level in the coolant reservoir using
the following procedure:
GENERAL MAINTENANCE
1. Open the hood
2. Check the coolant level in the coolant reservoir when the
engine is cold as the level will vary with changes in engine
temperature. The coolant level should be between the FULL
and LOW marks on the reservoir
2. If the fluid level is low, add coolant or distilled water to raise
it up the to FULL level
FULL
LOW
Hard water, tap water, or salt water is harmful the engine
and the cooling system components. Always use distilled
water or pre-mixed coolant (50:50 ratio) when adding fluid
to the coolant reservoir.
„ „
„ „ „
NOTE: If you have to add water to your UTV’s coolant,
have your KYMCO dealer inspect the coolant as soon
as possible to determine if it is in good condition.
„ „ „ „ „
NOTE: Dirt and debris must be cleaned from the radiator’s
fins regularly to ensure proper engine oil cooling.
Operating your UTV with high engine temperature may
result in engine damage or premature wear.
„ „ „ „ „
NOTE: High engine RPM, low vehicle speed, or heavy
load will raise engine temperature. Decreasing engine
RPM, reducing load, and selecting an appropriate trans-
mission gear can lower the temperature.
Periodically inspect the external condition of the radiator and
the coolant hoses. Look for leaks or damage on the cooling
fins of the radiator.
Never remove the radiator cap when the engine is warm.
The coolant in the radiator is very hot and under pressure
and can cause severe burns.