KYMCO UXV500, Руководство пользователя

Страница: 57 / 88

55
FEATURES & CONTROLS
HOOD
You can open the hood on your UXV500 to perform maintenance-
related tasks.
To open the hood, unhook the two rubber hood latches
3
and
release the six plastic fasteners
4
. Press the center of the plastic
fastener to release it and pull if from the hood and the fender. Lift
on the back of the hood to raise it (it is hinged in the front).
4 4
4 4
4
3 3
3 3
3
To close the hood, carefully
lower it back into place on the
chassis. Hook the rubber hood
latches
3
.
Reset the plastic fasteners
4
and insert them back into the
holes in the hood, the dash,
and the fender extensions. Set
the fastener by pressing the
center pin down so it is flush
with the fastener’s button head.
4 4
4 4
4
3 3
3 3 3
SWITCHES
Ignition Switch
The UXV500 ignition switch is a three-position, key-operated
switch, The key can be removed from the switch when it is in
the OFF position.
OFF:
Engine is off. All electrical circuits
are off (except accessory circuit).
ON:
The engine can run as the ig-
nition is powered. The electri-
cal circuits are on.
START:
The starter motor is engaged
by turning and holding the
switch in this position. Once
released, the switch will return
to the ON position.
Allow thirty seconds between starting attempts to allow
the starting motor to cool. Continuous starting attempts will
result in overheating and damage to the starting motor.