15
Chapter 2 Hardware Installation
the time offset directly.
DVB-T 730 can provide VGA, S-Video and composite
outputs to PC monitor, TV and VCR. It can also pass through
PC signal (VGA and audio) when DVB-T 730 is in standby
mode.
Please follow the connection steps and diagram below to
connect receiver to PC or TV.
2.1 PC Connection
This configuration will turn your PC monitor into a high
performance TV while you are not using PC.
Reset to Default
Set the box to factory default.
All the channel list, password, favorite channels will be
cleared.
1.
Connect the antenna output to “ANT IN”.
2.
You can use the “ANT OUT” port to provide DVB-T
signal to another DVB-T receiver box.
Switch the box to standby and turn on the power, box
will scan all
3.
“DIAG” is for diagnostics, please DO NOT use it as
USB port.
channels again.
4.
Use the VGA cable to connect the box “VGA OUT” and
PC monitor VGA input.
5.
Use the VGA cable to connect box “VGA IN” and PC
VGA out.
6.
Use 3.5mm Stereo cable to connect box “AUDIO IN”
(Blue jack) and PC Audio out.
7.
Use 3.5mm Stereo cable to connect box “AUDIO OUT”
(Green jack) and Speaker.
8.
Plug the power adapter to the “12V DC IN”.
2
