7
1. Pull the bolt handle back to lock the bolt.
2. Place the magazine into the magazine
well.
3. Push the magazine up until it clicks into
a locked position.
4. Pull the magazine down to assure that it
has been locked in place.
Locking Bolt
To lock the bolt, pull the bolt handle back to the rear of the gun.
WARNING: To avoid accidental discharge due to inadvertent
trigger pull, keep the manual safety engaged during loading or
unloading.
WARNING: Always keep finger off the trigger until ready to fire.
Make sure the muzzle is pointing in a safe direction.
WARNING: Before loading the magazine, the bolt must be in the
locked position to avoid damaging the cylinder.
LOADING MAGAZINE
16
SOLUTIONS
Add silicone to cylinder / main seal/ rails
Release hop-up or replace bucking
Replace magazine lip
Add silicone oil to valves / Replace valves
Replace base plate lock
Replace magazine base seal
Replace cylinder
POSSIBLE CAUSE
Dry internals
Hop-up adjustment too tight
Bended magazine lip
Dry O-ring
Broken base plate lock
Worn out base seal
Broken Cylinder tap
SYMPTOMS
Bolt jams / Will not complete cycle
Double feeds BBs into
chamber / BBs roll out of barrel
BBs will not release from magazine /
bent mag lip/ check BB condition
Leaking release valve & charging valve
Magazine base plate will not lock
Magazine base leaking air
Cylinder will not load BBs into chamber
!
!
!
SAFE
FIRE
Safety
Button
Pull Back to Lock Bolt
Bolt
Handle
BASIC TROUBLESHOOTING GUIDE FOR SMG
M11A1 NS2