KVH Industries TracVision R4, Инструкция по установке и эксплуатации

Страница: 3 / 13

3
Upgrading New TracVision Systems
If you are installing the Tri-Sat AutoSwitch Kit as
part of a new TracVision system installation, note
the following variations to the TracVision
Installation Guide.
• Only wire the receivers as specified in
these instructions
• Do not mount the switchplate until
you have finished installing the Tri-
Sat AutoSwitch Kit.
• Be sure to also wire the switchplate as
specified in the TracVision
Installation Guide.
Step 2 - Connect the Tri-Sat AutoSwitch Kit
This section explains how to connect the Tri-Sat
AutoSwitch Kit and a DIRECTV H21-200 or H20-
600 receiver.
NOTE: For information on wiring additional
components, refer to the Appendix on page 9.
a. Systems with a grounding block - Connect
the RF1 cable (A) from the grounding block’s
RF1 connection to the “From Antenna”
connector on the Tri-Sat AutoSwitch (see
Figure 3).
Systems without a grounding block -
Connect the antenna’s RF1 cable (A) to the
“From Antenna” connector on the Tri-Sat
AutoSwitch (see Figure 3).
Figure 3 Tri-Sat AutoSwitch Wiring Diagram
(A)
(B)
(C)
(D)
Standard
Receiver
(optional)
Antenna
RF1 RF2
RJ22 Connector on
Back of Switchplate
TracVision Switchplate
DB9 Connector on
Front of Switchplate
Previously Installed
TracVision Systems
From Antenna
To DIRECTV HD
Receiver Coax
USB
S-VIDEO OUT
COMPONENT OUT
AUDIO OUT
VIDEO OUT
C AU T I O N
OFF-AIR IN SATELLITE IN
DIGITAL AUDIO
OUT OPTICAL
HDMI OUT
PHONE JACK
RF REMOTE
ANTENNA
AC 120V, 60 Hz
Satellite In
USB
Grounding
Block
Vehicle
AC Ground
Control Output
To DIRECTV HD
Receiver USB
New TracVision Systems