3
Using Your TracVision L2
For TracVision L2 to receive the satellite signals, the antenna
must have a clear line of sight to the satellite. If you only receive
intermittent signals or the antenna cannot find the satellite, check
around your vehicle for any objects that could be blocking the
signal, such as trees, buildings, highway overpasses, etc.
You must also be located within the selected satellite’s coverage
area in order to receive its signal. Refer to your satellite television
service manual to check the viable coverage area. For your
convenience, KVH provides links to several web sites that offer satellite
coverage information. Simply go to our web site at:
3.1
Turning On the System
The TracVision L2 system is easy to use. To turn on the
TracVision L2 system, follow the steps below.
1. Turn on the IRD and the television. (
Refer to your
IRD user manual for complete operating
instructions for the IRD.)
2. Press the switchplate’s POWER button, as pictured
on the following page.
3-1
Using Your TracVision L2
54-0195 Rev. A
Figure 3-1
Be Aware of Objects that Might
Block the Satellite Signals
