10
Follow the steps below to seat up to four DSWMs
in the SWM expander.
a.
Seat up to four DSWMs in the SWM
expander. Secure them in place with the
locking tabs (see
).
b.
Connect an RF jumper cable (
supplied in kit
)
from each DSWM’s “PWR” connector to a
“PWR-SWM” connector (labeled “PWR-
SWM1” through “PWR-SWM4”) on the SWM
expander.
c.
Connect a SWM power inserter (
supplied in
kit)
to a “DC PWR IN” connector (labeled
either “DC PWR IN-1” or “DC PWR IN-2”)
on the SWM expander.
NOTE:
Connect a second SWM power inserter to
“DC PWR IN-2” if your installation exceeds two
DSWMs.
NOTE:
Do
not
connect the SWM power inserter’s
AC power cable to vessel power at this time. Power
will be connected in
.
Figure 12: DSWMs Seated in the SWM Expander
Locking Tab (x8)
AC Power
SWM Power
Inserter
POWER
TO SWM
DC PWR
IN-1
DSWMs
(Up to 4)
SWM
Expander
PWR
PWR
SWM1
Seat the DSWMs
7
