13
Follow the steps belows to connect power to the
system and set or verify the dish type or
configuration of each SWM receiver and/or DVR
connected to the TracVision system.
NOTE:
Refer to your selected receiver/DVR manual
for specific configuration instructions.
a.
Connect power to the TV-Hub and SWM
power inserters.
For details, refer to the
TracVision UHD7 Installation Guide.
b.
Press the Menu button on the receiver’s/
DVR’s remote control to display its menu on
the connected television.
c.
Navigate to the Satellite screen (Settings >
Settings & Help > Satellite) and select
Repeat
Satellite Setup
.
d.
At the Satellite Dish Setup menu, set the Dish
Type and RB/INTL to the settings below.
Switch Type should auto-populate:
Dish Type:
SL3 LNB
.
RD/INTL:
None Selected
Switch Type:
SWM Module 15 CH
e.
Make any necessary changes, then choose
Continue
to complete setup (see
).
f.
Repeat these steps for each connected
receiver and DVR.
The procedure is complete!
Figure 15: DIRECTV SWM Receiver/DVR Configuration
Configure the Receivers
9
