Kval 990-F4, Руководство по эксплуатации

Страница: 11 / 80

Overview of the 990-F4
1-3
KVAL 990-F4 Operation Manual
Options Available
Option Title Description
Option A Six Shooter Gun for 3-1/2'' X 3-1/2'' To attach 3-1/2" X 3-1/2" hinges to the door and jamb, No. 9 by 3/4"
long flat head screws are automatically sorted and fed, six at a time, to
the screw gun. Operator manually places the hinge onto the magnetic
indexing fixture and then rolls and pivots the Six Shooter into an "H"
block at each hinge location to attach the hinges. Pressing the 'Reset'
switch then raises the Six Shooter and feeds a set of six screws for the
attachment of the next hinge.
NOTE: Requires Option D: Pre-Drill System for Six Shooter.
The Six Shooter, which is supported on ball bearing equipped steel
wheels, is mounted on an overhead track that is precisely aligned to
ensure the hinge is properly position into the pocket at each hinge
location.
Option AC Metal Door Sensing Proximity
Switch
Allows operator to do the edge prep on a steel door without acciden
-
tally doing a face bore into the door.
Option AI Quick Change for Hinge Mortise
Dept
Each hinge router will be equipped with two stops than can be rotated
to set the hinge mortise depth. One stop for the primary hinge depth
and one stop for a second hinge mortise depth.
Additional stop plates can be ordered for other hinge thicknesses. The
stop plates are held in place with a single shoulder bolt
Option B Pushbutton Changeover from 3-1/
2" to 4" Hinge Pockets
Interior/Exterior option.
Option BC Ball Catch Drills Drill assemblies are mounted onto the lock boring section for drilling
left hand and right hand doors for drive-in ball catches. When selected
the proper drill automatically pivots in to drill into the top of the door.
Note, minimum door width for drilling is 18".
Option C: Pushbutton Selection for Two Face
Bore Backsets
Between 2-3/8" and 2-3/4". Manual adjustment takes 5 to 10 minutes.
Option D Pre-Drill System for Six-Shooter Twenty-four holes are pre-drilled and hinge pockets are blown clean
of any excess sawdust within five seconds following hinge pocket
routing sequence for hinge screw mounting holes. This option is
highly-recommended for all door and jamb materials.
Option E Two-Stage Drilling Allows changeover for two different face bore sizes with a selection
on the control panel.
Customer to specify 1-1/2” or 1-5/8” for dead bolt face bore when
ordering. Standard lock boring bit is 2/1/8".
Option G Automatic Positioning Door is power-fed into the machine and clamped into position. After
the hinges are attached, the door and jamb automatically off-feed as
the next door enters the machine
Option I Reverse Feed Facing the hinge routers, the normal direction is left to right.
Option IL Door Hand Indicator Light Light will be mounted on the out-feed end of the 990-F4 that can be
seen by the 700-C Assembly Table operator. The light will be on when
the door in the 990-F4 is being machined as a right hand door and off
for a left hand door.