
6
Fig. 3. DC motor tower Fig. 4. Black PVC Motor positioner
Fit the motor positioner on the top of the motor tower-see Fig. 4, then slowly move the motor
tower closer to the platter until the motor positioner touches the outer edge of the platter and
then take off the positioner. Fit the belt around the subplatter and then, stretching the belt, fit
it over the motor pulley. Rotate the motor tower to ensure that the belt is not touching the
grooves in the motor tower.
Rotate the platter carefully by hand to ensure that the belt is in the correct position. Fig. 5-6.
The motor brass cover can be fitted after the platter is on top of the subplatter. Slide the
cover onto the motor tower under the platter, fit in the two screws, rotate the cover and the
screws will lock in the correct holes. Then gently tighten them with the Allen key.
Fig. 5. Belt position in grooves
Fig. 6. DC belt drive Fig. 7. Control pad