12
13
Use the smart cap to make mixed juices,
stop juice from dripping, or rinse between different juices.
After juice and pulp are completely extracted, switch the unit OFF.
HOW TO OPERATE
After preparing the ingredients, plug the power cord into a wall outlet.
Press the FWD(FORWARD) button to operate.
Insert the prepared ingredients one piece at a time.
• Do not touch the power cord with wet hands.
It may cause electrical shock, short-circuit, or fire.
• Check the safety of the wall outlet.
• FWD(Forward) : Pulls down and slowly masticates the ingredients.
• REV(Reverse) : Pushes the ingredients back up to dislodge them.
• Fibrous leafy vegetables (celery, kale, etc.):
» Separate each stem. Cut the outer stems that are thick and tough to 10 cm long or less.
» Bundle up the leafy vegetables as inserting into the juicer. Alternate between leafy
parts and stems.
• Before extracting, remove hard seeds or pits in ingredients.
• When juicing frozen fruits with small seeds, ensure that even the seeds are completely
thawed.
• Insert the ingredients one piece at a time.
• Align the dots
●
and slide the pusher in.
• After inserting ingredients, use the pusher when it is necessary. Too much use of the
pusher may affect the juice quality.
» Intermittently use the pusher for soft ingredients like tomatoes and apples. Constant
use of pusher for soft ingredients may affect the juice quality.
• If the remaining ingredients in the juicing bowl have not been extracted
completely, the drum lid may not open easily. After each extraction, run the juicer
for an additional 30 seconds to let the juicer extract the remaining pulp.
• When the drum lid is stuck, press the REV(REVERSE) - O(OFF) - FWD(FORWARD)
button in this order; switching back and forth 2 or 3 times to dislodge the
ingredients. Then place hands on top of the drum lid and firmly press down while
simultaneously turning the drum lid counter clockwise to open.
» Depending on the ingredients, pour water down the feeding tube to rinse out
the interior of the juicing bowl and then attempt to remove the drum lid.
• Juicing with the smart cap closed creates various mixed juice creations when
different fruits and vegetables, milk, banana, beans etc. are selected.
• After juicing, close the smart cap to stop the juice from dripping, especially when
disassembling the juicing bowl off the base.
• When making different juices quickly rinse away any leftover flavors by running a
glass of water in the juicer with the smart cap closed.
• Leave the smart cap open when juicing ingredients that create excessive foam
during extraction, (e.g. apples, celery).
• Pay close attention when operating with the smart cap closed. Juice may overflow
if the juice collected in the juicing bowl exceeds its capacity marked on the bowl.
Note |
Note |
Note |
Tip |
Note |
Note |
Tip |
If the ingredients become jammed in the screw and the drum lid does not open, press the O(OFF)
button. Then press and hold the REV(REVERSE) button until the ingredients become dislodged.
Repeat REV(REVERSE) - O(OFF) - FWD(FORWARD) as often as needed to achieve the desired result.
STEP 1
STEP 3
STEP 4
STEP 5
STEP 2
If the juicer stops during operation:
Switch the button to O(OFF) position then press and
hold the REV(REVERSE) button until the ingredients
become dislodged.
Repeat REV(REVERSE) - O(OFF) - FWD(FORWARD) as
needed.
FWD(FORWARD) : Pulls down the food
O(OFF) : Stops the operation
REV(REVERSE) : Pushes the food back up
▶
▶
▶
4
1
3
2
O(OFF)
O(OFF)
REV(REVERSE)
FWD(FORWARD)
Note | · REV(REVERSE) : Pushes the ingredients back up to dislodge them.
The REV(REVERSE) button only works while holding down the switch.
· Switch O(OFF) ensuring that the juicer comes to a complete stop.
Then press REV(REVERSE).
Hold the REV(REVERSE) button for 2-3 seconds and release. Repeat as needed.
Let the juicer stop completely before using the REV(REVERSE) button to prevent malfunction.
· If the juicer does not work after these steps, disassemble and clean the parts before
operating the juicer again.
EN
Содержание 61120019
Страница 67: ......
