Page 6 of 9
ENG-0159.2
Regulator
The regulator pressure may be set too low and you may have to reset it. Remove the
silver label in the center of the regulator (where it says “Push to Turn”). By turning
the Phillips head or 3/32 hex screw found below this label, you can increase or
decrease the gas flow. Clockwise increases the gas flow, and counterclockwise
decreases the gas flow.
CAUTION:
You can increase the gas flow too much and the gas will not shut off.
Check this carefully after each adjustment.
CLEANING & MAINTENANCE
Cleaning
Stainless Steel exposed to high heat will change color over time. Discoloration of
components does not affect the operation or performance of the BBQ.
The exterior of the BBQ can be cleaned with soapy water. We recommend covering
the grill between uses,
Clean the grease from the Grease Tray on a regular basis.
Clean the heat plate on a regular basis. Build up of grease and food particles can
cause flare-ups or poor heat disbursement.
Maintenance
The following procedure will allow for the removal of the Burner Tube and Regulator
for cleaning or replacement.
Burner
The burner can be removed from the Barbecue by removing the machine screw
connecting the burner to the left side of the barbecue and sliding it out.
Regulator
1.
Remove the barbecue’s burner, described above.
2.
The orifice is located at the entrance to the burner. It is a brass fitting with a fine
hole that controls the maximum amount of gas to enter the burner.
3.
Remove the orifice from the barbecue using an 11/16” (17mm) wrench.
4.
Do not lose the spring washer that goes between the orifice and the regulator
housing. Observe the orientation of this washer for proper re-installation.
Adjustment screw
Содержание 83715
Страница 11: ......
