Kusina 600 Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 11

TURN OFF (700-900 Serie)

Turn the cooker gas button to pilot flame position “ ”, only pilot burn occurrs. Turn to
position “0” to turn off completely.
TURN OFF (600 Serie)

Turn to position “0” to turn off completely.
STARTING-UP THE OVEN (Figure E) (700-900 Serie)

Turn to the side part (11) to see the pilot burner

Turn the oven button (13) to pilot position by pressing it gently

Push button (14) and Ignite the pilot by pushing the button (12). Keep pressed button (14) for a few
seconds (min. 10) to heat the safety thermocouple end.

Then, you can adjust the heat by turning the button left according to the temperature degrees indicated
on the scale of button (11)
TURN OFF

Turn oven or its button to pilot position. In this position, only pilot burn occurrs. Turn to position “0”
to turn off completely.

Push button (15) then it will be off the oven

Wait min. 2 min before ignite the oven if turn off it by pushing button 15
MAINTENANCE

Never perform maintenance without closing the main gas valve of the device.

Before it cools down completely, wipe the device with a cloth immersed in warm soapy water.

Do not use cleaning substances and tools that may cause scratches on device surface.

If required, use chemical cleaners.

Do not clean the device with pressurized water or vapour.

Take out lower oil trays of oven and oven grates, and clean them with warm water and soap daily.

If the device will not be used for a long period, coat the surfaces with a thin layer of Vaseline.
ATTENTION:
Any part replacement that may affect safety must be carried out by the authorized
people. During maintenance and repair, keep the main gas valve closed and keep away fire.
Always perform leakage check after repair or part replacement; use foam or gas detector for
this aim.
In case of any dangerous condition with the device, notify to the authorized service.
Do not allow unauthorized people to interfere in the device.
DANGEROUS
: Never allow leakage check to be performed with flame.